completing the Arduino circuit and the washing

I have completed the circuit for Arduino, adding a second button (to be connected to a touch sensor). I have added these little buttons on the circuit to testing it without connecting the actual touch sensors.

Immagine Immagine Immagine Immagine

Then I have done some changes to the old sensors circuit, to adapt it to the new configuration:

Immagine Immagine

Then I have washed all the remaining case’s parts (the outer walls, the steel base and the structural joints):

Immagine Immagine Immagine Immagine Immagine

Leave a Reply

Your email address will not be published. Required fields are marked *